Filter
Top Products
17
Important Note: Use only a Power Wheels
®
battery with
A-style connector and built-in thermal fuse. Use of any
other battery can damage your vehicle. Make sure
that you charge the battery for at least 18 hours using the
enclosed Power Wheels
®
Super 6
™
volt charger before
operating your vehicle for the first time. Charge the battery
for at least 14 hours after each use of the vehicle. Never
charge the battery longer than 30 hours. Failure to follow
these instructions may damage your battery and will void
your warranty.
Do not discard the foam spacer that was packaged
with the battery!
1
• Press the tab under the back of the seat and lift to remove
the seat.
• Squeeze the battery retainer arms together to release
the arms from the slots in the vehicle body.
• Press the battery retainer arms in and over the lock
tabs and lift the battery retainer.
• Lower the battery retainer over
the battery and foam spacer.
• Fit the battery retainer arms down into the slots in the
vehicle body.
• Press the battery arms out over the lock tabs to snap and
secure the battery retainer arms in the slots.
• Re-assemble the vehicle seat.
• Place the battery upright in the battery compartment.
• Place the foam spacer in the battery compartment,
behind the battery.
• Plug the battery connector and motor harness connector
together. Push firmly to make sure the two connectors
are completely joined.
Vehicle
Body
Seat
Tab
Battery Installation
Battery
Retainer
Arms
Slot
2
3
Battery
Battery
Connector
Motor
Harness
Connector
Arm
Arm
SlotSlot
4
H
Incorrect Correct
GAP
NO GAP
Foam
Spacer