Filter
Top Products
Insert SD card into the SD card slot and gently press the
card in against the spring latch until it stops, then
release. The card will "lock" firmly into place inside the
SD card slot.
1.0 DIN Head Unit
GPS
Antenna
SD
CARD
2.0 DIN Head Unit
SMB
NAV Bus
Secure Smartbus Cable
with 11mm (.4in) Screw
NAV102 GPS Navigation System
RESET
G
P
S
AN
T
EN
NA
D
A
TA B
U
S
Insert one end of the Smartbus cable into the “DATA BUS” slot on the side of the NAV102
and secure it with a 11mm (.4in) screw (provided). Connect the other end of the cable to
the NAV102 input on the back of your compatible navigation-ready head unit.
Attach the GPS
Antenna to the
“ANTENNA”
jack on the side
of the NAV102.
Where applicable, secure the cable to the
radio using a 11mm (.4in) screw.
Some compatible head units have a cable to cable
connection and do not require an anchor screw.
NAV102 Wiring Diagram