Jeep 74383 Motorized Toy Car User Manual


 
IMPORTANT
A 25 AMP FUSE MUST
BE INSTALLED IN TOP
OF BATTERY BEFORE
TOY WILL RECHARGE
OR OPERATE
®
Insert a Power Wheels
®
25 amp fuse into the battery.
Note: The top of the fuse will not be flush with the top of the
battery when properly installed.
25 Amp Fuse
Battery Charging
8
1
2
3
Plug the charger into a standard 120 volt wall outlet.
Note: If power flow to the wall outlet is controlled by a
switch, make sure the switch is ON.
Before first time use, charge the battery for at least 18
hours. Never charge the battery longer than 30 hours.
Note: The battery must be upright while charging.
Recharge the battery after each use of your vehicle for
at least 14 hours. Do not charge the battery longer than
30 hours.
Once the battery is charged, disconnect the charger
connector from the battery connector. Unplug the charger
from the wall outlet. The battery is now ready to be
installed in your vehicle. Please see “Battery Installation”
on page 24 for detailed instructions on installing your bat-
tery. If your battery is already installed in your vehicle,
simply re-connect the battery connector and motor har-
ness connector and
re-assemble the seat.
®
®
Plug the charger connector into the battery connector.
Battery
Connector
Charger
Connector
Charger
74388pr-0921.qrk 7/13/01 1:38 PM Page 8