Filter
Top Products
4
5. Installation
1. When making electrical connections it is always recommended that the vehicle’s
battery be disconnected from the electrical system before performing the
installation.
Please Note: If the radio is equipped with a built in CD
Changer, you must remove ALL discs before proceeding to
prevent damage to the radio’s CD mechanism.
2. Carefully remove the trim panels covering the 7mm bolts that secure the radio into
the dash cavity. Remove these bolts, and carefully pull the radio from the dash of
the vehicle. This will provide access to the factory radio connectors where you will
connect the GateWay harness.
3. Disconnect the factory 24-Pin harness and 16-Pin harness from the back of the
radio.
4. When connecting the Satellite Radio tuner (SXV100 sold separartely), make the
folllowing connections before connecting the GateWay to the vehicle. Plug the
black end of the 3 foot ISSR12 (8-Pin mini-din to 10-Pin mini-din) into the rst
port (farthest from the dipswitches) on the GateWay. Connect the gray end of
this cable into the Satellite Radio tuner.
5. Plug in the male connectors on the PGHGM5 harness into the 24-pin port and
16-pin port on the back of the radio. Next, connect the factory 24-pin and 16-pin
harness into the female connectors on the PGHGM5 harness. Be sure to make a
rm connection but do not force it. Plug the Black micro-t 24-pin connector on the
PGHGM5 harness into the GateWay.
6. To complete the installation secure the GateWay (GateWay) and Satellite
Radio tuner (SXV100) into the cavity in the dash behind the radio. Be sure that the
cables and interface modules are not near moving parts or sharp metal edges as
they may damage the cables. To prevent rattling noises inside the dash, use zip
ties, tape, or other fasteners to mount the interfaces securely.
7. With all connections made, reconnect the vehicle’s battery, insert the key into the
ignition, and turn the vehicle on. Check for proper operation of the GateWay
and Satellite Radio tuner before reinstalling the factory dash panels.
8. Note: The rst time you access the Gateway, your radio may display “DEV INIT”
while the device is initializing. If this is displayed, please wait one minute then
cycle the ignition off and on. Then access SAT mode again to begin normal
Gateway operation.
6. Sirius Satellite Radio Operation
Basic Features
Entering Mode Select Menu
Press the “BAND” button a few times until “XM” is displayed on the screen.
Immediately turn the TUNE KNOB to scroll through the available sources. Once
“SIRIUS/XM” is displayed, press “PRESET 6” to select the displayed mode.
Channel Up
Turn the TUNE KNOB clockwise to move up through the channels
Channel Down
Turn the TUNE KNOB counter-clockwise to move down through the channels
Category Up
Press the “SEEK>” button to move up through the categories.
Category Down
Press the “<SEEK” button to move down through the categories.
Store Presets
Tune to the station you want to store as a preset. Press and hold the preset button on
which you want to store the channel.
Recall Presets
Press the preset button that corresponds with the channel you want to recall.
Changing Display:
Press the “DISPL” button to display artist and track information