Filter
Top Products
3939
C
O
N
T
R
O
L
L
E
R
FIGURE 2 - REMOVING/INSTALLING
CONTROLLER FROM/TO CONTROLLER PLATE
PANTHER MX - 4
LYNX SX - 3P AND LYNX SX - 3
LYNX LX - 3 AND PANTHER LX - 4
Retaining
Tab
Short
Screws
Self-locking
nuts
Washer
Controller
Controller
Plate
Rear
Frame
Support
Retaining
Tab
Washer
Retaining
Tab
Short
Screw
Self-locking nuts
Washer
Controller
Controller
Plate
Rear
Frame
Support
Retaining
Tab
Washer
Long
Screw
Screws
Washer
Controller
Self-locking
nuts
Rear Frame/
Controller Plate
REMOVING/INSTALLING
CONTROLLER HARNESSES
Lynx SX - 3P And Lynx SX - 3
(FIGURE 3)
REMOVING.
1. Disconnect the controller wires. Refer to DISCON-
NECTING/CONNECTING CONTROLLER
WIRES in this procedure of the manual.
2. Disconnect the RED and BLACK connectors of
the power wiring harnesses from the RED and
BLACK connectors of the controller wiring har-
nesses.
3. Disconnect the WHITE connector of the transaxle
assembly wiring harness from the WHITE con-
nector of the controller wiring harness.
NOTE: Note the positions of the metal connectors
before removing for proper reinstallation.
4. Disconnect the metal connectors of the control-
ler wiring harnesses from the metal connectors
of the circuit breaker.
5. Disconnect the BLUE connector of the tiller wir-
ing harness from the BLUE connector of the con-
troller wiring harness.
6. Disconnect the YELLOW connector of the tiller
wiring harness from the YELLOW connector of
the controller wiring harness.
7. Cut the cable ties securing the transaxle wiring
harness to the rear frame.
8. Cut the cable tie securing the power wiring har-
nesses and the tiller wiring harnesses to the rear
frame.
9. Cut the cable tie securing the tiller wiring har-
nesses to the retaining tabs of the controller.
10. Remove the tiller wiring harnesses from the retain-
ing tabs.
11. Remove the wiring harnesses from the scooter.
INSTALLING.
1. Position the tiller wiring harnesses in the retaining
tabs.
2. Secure the tiller wiring harnesses to the retaining
tabs using NEW cable ties.
3. Secure the power wiring harnesses and the tiller
wiring harnesses to the rear frame using NEW
cable ties.
4. Secure the transaxle wiring harnesses to the rear
frame using NEW cable ties.
CONTROLLER PROCEDURE 7
Slot
Slot