Filter
Top Products
1616
PROCEDURE 4 TILLER
T
I
L
L
E
R
Section C - Disconnecting/Connecting
Head light Assembly (FIGURE 6)
DISCONNECTING.
1. For LYNX LX - 3 ONLY - slowly pull the head light
assembly away from the base handle bar joint.
2. Pull back the plastic guards on the RED and
BLACK cables connecting the tiller wiring har-
ness to the head light assembly.
Metal
Connectors
Tiller
Wiring
Harness
Plastic
Guards
Red/
Black
Cables
Red/Black
Cables
Head
light
Assembly
(LYNX SX - 3P)
Red/Black
Cables
Metal
Connectors
Plastic
Guards
To Tiller
Wiring
Harness
To Head
Light
Assembly
3. Disconnect the RED and BLACK cable metal
connectors of the head light assembly from the
RED and BLACK cable metal connectors of the
tiller wiring harness.
4. Separate the head light assembly from the tiller
wiring harness.
5. Refer to the chart on page 11 of this manual to
determine which section(s) need to be performed
next to successfully complete the removal/instal-
lation of the tiller assembly.
(PANTHER LX - 4)
Plastic
Guards
Red/Black
Cables
Metal
Connectors
Tiller
Wiring
Harness
Red/Black
Cables
FIGURE 6 - DISCONNECTING/CONNECTING HEAD LIGHT ASSEMBLY
Head light
Assembly
(PANTHER MX - 4)