Filter
Top Products
OPERAT
OR’S MANUAL
651615–X
RELEASED:
2–25–95
REVISED: 6–21–10
(REV. C)
INCLUDING: OPERATION, INSTALLATION & MAINTENANCE
SINGLE POST LIFT/RAM
For use with 5 Gallon Drums (Tapered or Straight)
READ THIS MANUAL CAREFULL
Y BEFORE INST
ALLING,
OPERA
TING OR SER
VICING THIS EQUIPMENT
.
THIS MANUAL COVERS THE FOLLOWING MODELS
MODEL TYPICAL PUMP APPLICATION
651615 3'' & 4-1/4'' AIR MOTORS (TIE ROD PUMPS)
SERVICE KITS
Rebuild Kit for E512LM Valve - 116722
Repair Kit for 127112-000 Miniature Regulator - 104158
GENERAL
DESCRIPTION
The ARO Model 651615-X Single Post Lift/Ram uses a 3-1/2'' air-
powered cylinder whichis weldedto a heavygaugebase base.Itis norĆ
mally used to raise and lower a fluid handling pump and follower in and
out of of standard 5-gallon drum or when used as a ram it can force
high viscosity flowable material into the pump inlet.
When properly secured, this unit has the ability to raise a pump toclear
a standard 5-gallon drum. The operator is then able to easily remove
the pump from a pail.
This Lift/Ram uses a hand lever4-way control valve which controls the
air necessary to raise and lower the lift. This unit includes an auxiliary
manual air valve which is used to supply a controlled amount of air
pressure to the bottom of the follower plate. When the Control Valve is
in the ``UP'' position a small amount of air pressure applied under the
follower plate will help to raise the follower plate, pump and lift by reĆ
lieving the vacuum. See Page 3.
BASE DIMENSIONS: 20'' SQUARE (508 mm)
HEIGHT: LOWERED 36-3/4'' (.9m), RAISED 56-1/4'' (1.7 m)
651615
SINGLE POST LIFT
INGERSOLL RAND COMPANY LTD
209 NORTH MAIN STREET – BRYAN, OHIO 43506
(800) 495-0276 FAX(800) 892-6276
© 2010
www.ingersollrandproducts.com