Filter
Top Products
Cleaning the Vehicle
2005 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual Page 45
CLEANING THE VEHICLE
Husqvarna vehicles are equipped with ABS front bodies and TPO for rear bodies. Use only commercially
available automotive cleaners with a sponge or soft cloth for normal cleaning. A garden hose at normal resi-
dential water pressure is adequate.
Husqvarna does not recommend any type of pressure washing or steam cleaning. Such a process (especially
if the vehicle has the rear body removed) will expose electrical components to moisture. Moisture entering
electrical components can result in water damage and subsequent component failure.
Use non-abrasive wax products. Battery acid, fertilizers, tars, asphalt, creosote, paint, or chewing gum should
be removed immediately to prevent possible stains.
The seats of the vehicle will last longer with proper cleaning. Use a solution of 10% liquid soap and warm
water applied with a soft cloth. For imbedded dirt, a soft bristle brush may be used. For heavy soiling, difficult
stains or scratches, blemishes, or other body damage, see Section 4 of the appropriate maintenance and ser-
vice manual.
NOTE: Dispose of waste water properly.
ACCESSORIES
There is a complete line of accessory equipment available from Husqvarna and our dealers/distributors. You
can obtain the name and phone number of your closest Husqvarna contact by visiting our web site at
www.usa.husqvarna.com.
Care should be taken that these accessories are properly installed by trained technicians, and that they are
used in the manner for which they were designed.
SUBSEQUENT OWNER REGISTRATION
In the event a vehicle is bought as a used vehicle, we strongly urge the new owner to register the vehicle with
Husqvarna. This will enable us to contact you if the need arises. Please send your name, address, and serial
number of the vehicle to Husqvarna, 7349 Statesville Rd., Charlotte, NC 28269, Attention: Vehicle Registra-
tion.
Figure 32 Fuel Tank
VENT TUBES
SHUT-OFF
VALVE
VENT