Filter
Top Products
Instructions for Use
•Plug corded recharger into 120-volt outlet.
•Plug small end of recharger cord into massager’s base. Red light on massager’s
base will illuminate – indicating that unit is in charge mode. Allow unit 3 hours
to fully charge.
•Remove recharger cord from both massager and 120-volt outlet. MASSAGER
WILL NOT OPERATE UNLESS RECHARGER IS UNPLUGGED FROM UNIT’S BASE.
Massager will run approximately 30 minutes on this charge, depending on vibra-
tion setting.
•To activate Massage, slide switch up towards the massage head. The first posi-
tion (I) is Low intensity and the second position (II) is High intensity.
•Lightly apply curved massage head to the area you wish to massage. Massage
the area for a short period of time and move to another area. Never massage the
same spot for longer than 3 minutes. CAUTION- as stated in the “IMPORTANT
SAFEGUARDS” section of this manual, never use this appliance near the eyes
or other sensitive areas.
•Operation of longer than 20 minutes is not recommended and may cause
overheating of the massager.
Maintenance
To Clean
Be sure to unplug the unit and allow it to cool before cleaning. Use a soft, slightly
damp cloth to wipe. Never allow water or any liquids to come into contact with
the handle. Never use abrasives, detergents or cleaning agents to clean.
To Store
Unplug the appliance from the outlet and allow it to cool before storing it in its
box, or a clean, dry place. Do not wrap the recharging cord around the unit. Do
not hang the unit by its recharging cord.
HydraGel™ Dampening System
Isolates vibration to the massage head
Recharge Outlet
Ergonomic Handle
Extruded Rubber Gripping
For ease of handling
Massage Switch
Choose Low or High Intensity
Curved Massage
Head for Invigorating
Vibration.
7
HG-10_A.qxd 7/24/08 3:17 PM Page 7