Filter
Top Products
3. Installing the bicycles on the F10 Elevator Rack
A. The heaviest bike should be loaded on first closest, the lightest on the outside. Place the
first bicycle on the support arms closest to the main frame (2.) of the rack. The handlebars of the
first bike should be on the passenger’s side of the vehicle. Rotate the crank arm so that the
pedal does not contact the vehicle. Thread the tie down strap (not pictured) around the main
frame, and through the buckle. Tighten the strap securely. Adjust the other tie down strap
accordingly.
B. Install the 2
nd
bicycle with the handlebars on the opposite side of the first bicycle. Adjust
the ties down straps as per the above instructions.
C. Use the nylon safety strap (attached to the support arms) to help secure the bicycles to
the rack. This strap must be routed behind the main frame of the rack and through the bicycles.
Be sure to tighten all straps both before and after mounting bicycles on the rack! Be sure
all knobs are tight before driving the vehicle!
Tip: Women’s, children’s and/or small frame bicycles can be mounted on the rack by placing
the bicycle on the support arms under the down tube and behind the seat tube (under the seat
stays).
4. Removing and storing the F10 Elevator rack:
Remove bicycles and tie down straps from the rack. Loosen the upper knobs and lower the
bicycle support arms. Lift up on the release tabs of the buckles and unhook the straps from the
bumper or rear door. Remove the rack from the vehicle. Loosen the middle knobs and fold the
rear brace forward. Loosen the lower knobs, and fold the lower “U” frame back against the main
frame. Tighten all knobs to keep the F10 Elevator rack in a tightly folded position until further
use is required.
Limited Lifetime Warranty (effective January 1, 2008):
Hollywood Racks will warrant its car racks and accessories during the time that an original retail purchaser
owns the product subject to the exclusions and limitations of this warranty. Hollywood Racks will remedy defects in
materials and workmanship by repairing or replacing (at its option) a defective part or the complete rack without
charge for labor or parts. Hollywood Racks may elect (at its option) to issue a refund equal to the purchase price
paid for the product. This warranty does not cover problems caused by normal wear and tear including (but not
limited to) weather, scratches, dents, rust, accidents, unlawful vehicle operation, misuse, abuse, neglect, theft,
unauthorized modifications, or unauthorized repair. No warranty is given for defects resulting in incorrect assembly,
incorrect installation onto the vehicle, incorrect attachment of bicycles onto the rack, or overloading of the rack’s
weight restrictions. This warranty terminates if the original retail purchaser transfers the
product to any other person.
If a product is believed to be defective, the original retail purchaser should contact either the original retailer
.
Disclaimer of Liability: Repair or replacement of a defective product or the issuance of a refund or credit (as
determined by Hollywood Racks) is a purchaser’s exclusive remedy under this warranty. Damage to a purchaser’s
vehicle, cargo, bicycles and or to any other person is excluded. This warranty is expressly made in lieu of any and
all other express warranties, whether oral or written. Hollywood Racks shall not be liable for any direct, indirect,
consequential, incidental, special, punitive or any other damages in connection with the purchase, use or handling of
this product.
Hollywood Racks
12812 South Spring Street Los Angeles, CA 90061 USA
Tel (310) 516-8600 Fax (310) 516-8955
Customer Service Hours: M-F 7:00 AM - 3:00 PM Pacific Standard Time
info@hollywoodracks.com www.hollywoodracks.com
Made in Taiwan 110508 Rev C
3