Filter
Top Products
C-VS-800-CV_INST_9-07
3
Remove wire plug going to
Ashtray/Power point frame
assembly
Power point detached from
assembly
Drill out spot-welds that hold the
power point bracket to the frame. This
needs to be removed in order for the
console to slide into the rail
Ashtray frame rail re-assembled
Slide console into ashtray
frame slide rails
Re-install ashtray frame bracket
Re-route HVAC controller and the
AM/FM radio harness and antenna
to the VS console
It is necessary to notch the OEM
ashtray/power point frame assembly if
relocating the HVAC controls to the VS
console. This will allow the HVAC
vacuum hoses to reach the VS console
Notch
Note: If NOT relocating
AM/FM radio and/or
HVAC controls, resume
installation at this point