Filter
Top Products
C-VS-0812-CHGR_INST_12-07
3
View of installation to this point
Note: Be sure OEM wiring is not
being crushed by mounting
brackets
Place console assembly and
install extension (#10) for “L”
bracket mounting leg on stout
console, using OEM hardware.
Attach “L” bracket mounting
leg (#9) to rear
floor filler panel
(#6) using ¼-
20 x ¾” hex bolts
and serrated nuts.
Remove OEM supplied trak.
Note: Some hardware is re-
used
in installation of console
View of trak removed
Attach frame support bracket
(#4) to vehicle using 10/32 x ½”
phillips machine screws,
washers, and keps nuts
Attach support bracket for stout
console (#2) to vehicle and to frame
support bracket using OEM hardware
and #10 x ½” phillips machine screws
and washers
Tighten hardware
Attach frame support bracket
(#4) to vehicle using 10/32 x ½”
phillips machine screws,
washers, and keps nuts
Note: Due to some slight differences on the OEM floor mount bracket, tabs with mounting hole may
need to be bent sligh
tly to accommodate the console front support bracket. Bending these tabs can easily
be done using pliers.