Havis-Shields C-TM-IMP Automobile Accessories User Manual


  Open as PDF
of 2
 
C-TM-IMP-INST-2-07
2
INSTALLATION:
1. REMOVE SEATS:
• Remove rear seat base torx bolts.
• Slide seat to rear most position.
• Seats do not have to come out of vehicle, they will just need to be tilted out of way to
place Trak-Mount assembly. Be careful of wire plugs if vehicle has power seats.
2. MOUNT ASSEMBLED TRAK-MOUNT:
• Place Trak-Mount assembly so front bracket sets squarely on floor beam straddling
seat bolts – lag bolt to the floor beam. The rear hump brackets are place on floor
between floor of vehicle and seat base and can be mounted using the rear seat bolts.
• Re-mount seats over Trak-Mount assembly and tighten all hardware.
• Mount equipment (consoles, control heads, etc), prior to plastic end caps, for access
to hardware slots.
Rear Hump Bracket
(Driver Side)
Rear Hump Bracket
(Pass. Side)
Front Hump Bracket
Trak
 previous