Havis-Shields C-TM-GMC Automobile Parts User Manual


  Open as PDF
of 2
 
C-TM-GMC_INST_4-08
2
Remove OEM trim panel covering front inner
seat bolts on driver and passenger sides.
Remove seat bolt nuts.
15 mm socket required.
Installation:
Remove OEM trim panel covering rear inner
seat bolts on driver and passenger sides.
Remove seat bolt studs.
11 mm socket required.
Loosely pre assemble front hump bracket
with 1/4” x 3/4” bolts and fl at washers, then
position it under the OEM front seat brackets.
Loosely pre assemble rear hump bracket
with 1/4” x 3/4” bolts and fl at washers, then
position it under the OEM rear seat brackets.
Determine the position of Trak desired and
mark location with a pencil on the hump
brackets.. Remove the front and rear hump
bracket cross support.
Insert 1/4” x 3/4” bolts into the bottom of Trak.
Line up Trak on cross supports where previously marked.
Use 1/4” serrated nuts to attach.
Reattach Trak with cross supports back onto seat brackets.
 previous