Havis-Shields C-TM-CV Automobile Accessories User Manual


  Open as PDF
of 2
 
C-TM-CV-INST-2-07
2
• Attach trak to rear hump bracket using (2) ¼-20 x ¾” Hex head bolts and serrated
nuts.
Note: There is a driver and passenger side bracket to the Rear Hump Bracket. Top of
brackets will be parallel to the transmission hump.
INSTALLATION:
1. REMOVE SEATS:
• Remove rear seat base nuts (18mm).
• Slide seat to rear most position.
• Remove front seat base bolts (13mm).
• Seats do not have to come out of vehicle, they will just need to be tilted out of way to
place Trak-Mount assembly. Be careful of wire plugs if vehicle has power seats.
2. MOUNT ASSEMBLED TRAK-MOUNT:
• Attach the driver and passenger side front hump brackets to the inner front seat bolts.
• Place Trak-Mount assembly so rear hump bracket are between floor of vehicle and
seat base.
• Re-mount seats assembly and tighten all hardware.
• Mount equipment (consoles, control heads, etc).
Front Hump
Bracket
Rear Hump
Bracket
(Pass. Side)
Rear Hump
Bracket
(Driver Side)
Trak
 previous