Filter
Top Products
INSTALL INSTRUCTIONS C-TM-CV
1995-2007 FORD CROWN VICTORIA TRAK-MOUNT KIT
TOOLS REQUIRED:
Ratcheting Wrench
Metric Socket Set
Standard Socket Set
Tape Measure
HARDWARE:
QTY DESCRIPTION PART#
10 ¼” x ¾” Hex head bolt GSM33001
6 ¼” Serrated nut GSM30023
4 ¼” Flat washer GSM31005
4 ¼” Split lock washer GSM31026
SUB ASSEMBLY:
1. MOUNT TRAK TO HUMP BRACKETS.
• Determine location that Trak will land on transmission hump for the specific
application.
• With Trak in necessary location, measure Front and Rear Hump Bracket in relation to
Trak.
• Bolt trak to the front hump bracket, top plate using measurements taken in previous
step. Use (4) ¼-20 x ¾” Hex head bolts and serrated nuts.
Note: There are 2 different sides to the Trak Plate. It is recommended to mount Hump brackets to
side of Trak Plate that has ¼” hardware slots closer together, to better accept equipment, (consoles,
control heads, etc)
Trak Mount
Rear Hump
Brackets (C-B16)
Front Hump
Bracket (C-B33)
¼” Hardware
Slots
TRAK-MOUNT ASSEMBLY