Havis-Shields C-TCB-9 Automobile User Manual


  Open as PDF
of 2
 
C-TCB-9-INST-7-05
SUB ASSEMBLY:
1. Confirm receipt of all hardware and components.
2. Remove front inner and outer passenger seat bolts on vehicle.
INSTALLATION:
1. Mount C-TCB-9 into vehicle:
• Position pole support assembly between seat base mount and floor of vehicle
• Align holes in pole support assembly with holes in seat base.
• Loosely attached factory seat bolts that were removed during subassembly.
• Mount side support brace to threaded rod located on pole support assembly using a
5/16-18 Nylock nut
• Mount side support brace to vehicle using ¼” x ¾” Hex head lag bolts. A 3/16” pilot
is required.
Note: When mounting side support brace to floor of vehicle, be sure to check for obstructions prior to
drilling or lag bolting to floor.
• Tighten down passenger side factory seat bolts and 5/16-18 nylock nut holding side
support brace to pole support assembly.
• Mount optional C-3090, computer-mounting platform, to telescoping pole assembly
using hardware and instructions provided with C-3090.
 previous