Hasbro 22613 Motorized Toy Car User Manual


  Open as PDF
of 4
 
ASSEMBLY
RULER
ROLLER
4.
Stand table on legs. Snap
carousel onto tabletop.
Snap FUZZY PUMPER®
post onto tabletop. Snap
FUN FACTORY® extruder
onto tabletop.
5.
Fit 4 shelves into either of
the legs with shelf slots.
6.
Slide roller onto ruler.
3. Push and snap legs onto table as shown. Be sure to match the
letter on the leg with the letter on the table.
2.
Turn tabletop assembly
over. Use a Phillips/
cross head screwdriver
to tighten 3 screws into
tabletop center/end on
one side. Repeat for
other side.
1. Fit 2 tabletop ends onto tabletop center.
TABLETOP
CENTER
TABLETOP ENDS
FUZZY PUMPER POST
CAROUSEL
FUN FACTORY
EXTRUDER
SHELVES
NOTE: Be sure
to insert each
table leg at a
slight angle (as
shown). Gently
rock each leg
into place until
an audible
“snap” is heard.
 previous next