Filter
Top Products
TO ASSEMBLE
There are several easy assembly steps you’ll need to follow to get started:
1. Snap the castle front into the castle base as shown.
2. Snap the roof/slide to the castle front as shown.
3. Snap the slide to the points on the castle front and the
castle base as shown.
4. Snap the wobbly turret to the castle front as shown.
NOTE: To test whether the piece is secure, pull lightly
on the turret. If the turret remains in place, it is secure.
If it can be removed easily, push the turret into place
again with increased pressure until both tabs lock.
5. Attach the drawbridge ramp to the front of the castle
base as shown.
6. Place the lookout turret on top of the castle as shown.
7. Snap the throne to the back of the castle base as shown.
8. Attach the staircase to the rear of the castle base
as sh
own.
1.
2.
3.
4.
5.
6.
7.
8.
Use a Phillips/cross head screwdriver
(not included) to loosen screw in
battery compartment door. Remove
door. Insert 3 x 1.5V “C” or R14
size batteries. Alkaline batteries
recommended. Replace door and
tighten screws.
TO INSERT BATTERIES
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified
and be sure to insert them correctly by matching the + and – polarity
markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc)
with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical
interference, move it away from other electrical equipment. Reset
(switching off and back on again or removing and re-inserting
batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types
of battery. Always remove from the product before recharging.
Recharge batteries under adult supervision. DO NOT RECHARGE
OTHER TYPES OF BATTERIES.
CAUTION: TO AVOID BATTERY LEAKAGE
1) Be sure to insert the batteries correctly and always follow the toy and
battery manufacturers’ instructions.
2) Do not mix old and new batteries or alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries.
3) Always remove weak or dead batteries from the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.