Filter
Top Products
TO REPLACE BATTERIES
Open seam on back to access
electronic unit. Using a Phillips/
cross head screwdriver (not
included), loosen screw in
battery cover (screw will remain
attached to cover). Remove old
batteries and insert 3 fresh 1.5V
“AA” or R6 size batteries into
battery compartment. Alkaline
batteries recommended. Replace
cover, retighten screw, and put
electronic unit back inside
with the light and button
facing forward. Tie unit into
place and close seam to
conceal electronic unit.
TO USE
NOTE: This product is shipped
in “demo” mode. Open seam on
back and slide switch to “play” for
full use at home. If GLOWORM
toy electronics accidentally halt,
remove batteries for 10 seconds
to reset the electronics. Follow
the “To Replace Batteries”
instructions for information about
removing and replacing batteries.
Open back, untie laces and
remove electronic unit. Place
the toy in pillow case and tie
end closed. Machine wash
in cold water, gentle cycle,
mild detergent, NO BLEACH.
Tumble dry in pillow case on
low heat setting. After the toy
is dry, distribute filling evenly
throughout body. (During
washing, filling may bunch up.)
Place electronic unit in the toy
with the bulb toward the face
and the activation button facing
forward. Fit lace through tab on
each side of unit and tie to other
lace. Close seam.
TiesTies
WASHING INSTRUCTIONS
(DO NOT WASH TOY WITH ELECTRONIC UNIT INSIDE!)
PLAY FEATURES
Your child’s LULLABY GLOWORM friend may ease the transition to
bedtime with a friendly, glowing face and soothing lullaby songs.
1.
Gently press the patch on your lovable friend for a glowing
light and to start music. Each time your GLOWORM friend is
squeezed, he will play 1 of 6
lullaby songs.
2.
For quiet time, move switch to
“light” so that your GLOWORM
friend can light up without
making a sound.