Filter
Top Products
Page 4SKU 95967
For technical questions, please call 1-800-444-3353.
When servicing a tool, use only identical replacement parts. Follow instructions
in this manual. Use of unauthorized parts or failure to follow maintenance instruc-
tions may create a risk of injury.
SPECIFIC SAFETY RULES
NEVER use the Flat Bottom Jack unless it is properly and securely attached
first.
WARNING: DO NOT exceed the maximum lift capacity of 8 Tons (~16,000
pounds). Exceeding the maximum lifting capacity is dangerous and could cause
serious injury or property damage.
Maintain labels and nameplates on the tool. These carry important information.
If unreadable or missing, contact Harbor Freight Tools for a replacement.
Maintain a safe working environment. Make sure there is adequate surrounding
workspace. Do not use this product in a damp or wet location.
Do not alter Flat Bottom Jack’s 16.5 mm (0.65”) mounting hole. A mounting
pins (not included) must be used that is rated to support at least 8 Tons of pressure
and it must have R-Pins (not included) to lock the pin in place.
Use the Flat Bottom Jack only on a flat, level and solid surface capable of
supporting the combined weight of the lifting equipment, crane and load.
The Flat Bottom Jack is designed to lift loads only for short periods of time.
Do not use Long Ram Jack to suspend a load for more than 30 minutes at a time.
Immediately after lifting, brace load with support equipment rated to handle
the load capacity. Do not work under a load suspended only by the Flat Bottom
Jack.
Do not attempt to move or shift object being lifted.
Twisting or sideways force exerted on the Jack could cause it to fail.
Do not attempt to move a load while it is supported by the Flat Bottom Jack.
The Jack must be used in a fixed position when lifting and lowering loads.
Before lowering a load, be certain that the area underneath the load is clear
of obstructions and personnel.
Industrial applications must meet OSHA requirements.
Use compressed air only. Use only clean, dry, regulated, compressed air between
110 and 120 PSI. Never use Oxygen, Carbon Dioxide, combustible gases or any
other bottled gas as a power source for this product.
2.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.