Filter
Top Products
Page 4SKU 95896
For technical questions, please call 1-800-444-3353.
Never load Dolly by riding motorcycle onto it.
No one should ever sit on the motorcycle while it is loaded on the Dolly.
Do not allow children to play on or around motorcycle when loaded. Do not
allow children to play on Dolly. Children should not be allowed in work area when
motorcycle is being loaded or when Dolly is in use.
UNPACKING
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number shown on the
cover of this manual as soon as possible.
ASSEMBLY
Attach five Casters Assemblies (4) to Frames (1,2) and Side Tray (3) with M6 Bolts
(9), #6 Washers (10) #6 Lock Washers (11) and M6 Nuts (12).
Bolt Connecting Plates (5) to both sides of Carriage A (6) and Frame A (1) with M6
Bolts (9), #6 Washers (10), #6 Lock Washers (11) and M6 Nuts (12).
Bolt Connecting Plates (5) to both sides of Carriage B (7) and Frame B (2) with M6
Bolts (9), #6 Washers (10), #6 Lock Washers (11) and M6 Nuts (12).
Connect Frame A and Frame B together with Connecting Pipes (8) using M8 Bolts
(14), #8 Washers (15), #8 Lock Washers (16), and M8 Nuts (17).
Bolt Side Tray onto Frame Assembly with M8 Bolts (14), #8 Washers (15), #8 Lock
Washers (16), and M8 Nuts (17).
Insert the two Stop Pins (13) into slots at each end of the Frame Assembly and
firmly tighten.
OPERATION
BEFORE EACH USE, inspect the general condition of the Dolly. Check for loose
screws, misalignment or binding of moving parts, cracked or broken parts, and any
other condition that may affect its safe operation. If abnormal noise or vibration occurs,
have the problem corrected before further use. Do not use damaged equipment.
Test Dolly to make sure it rolls smoothly.
Put Handles on Carriage A (6) and Carriage B(7) down to lock Dolly in place.
Remove Stop Pin (13) and push motorcycle onto Dolly. For safety, it is recommended
that 2 people balance and roll the motorcycle onto Dolly.
Lower motorcycle kickstand onto Side Tray (3) and rest motorcycle in place.
Replace Stop Pin.
Secure motorcycle securely to Dolly using belts or straps (not included).
Raise handles on Carriage A and Carriage B to move Motorcycle with Dolly.
See Examples on next page.
9.
10.
11.
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
5.
6.
7.
8.