Filter
Top Products
SKU 94813 For technical questions, please call 1-800-444-3353 PAGE 10
OPERATING INSTRUCTIONS
1. WARNING! Do not exceed the maximum lifting capacity of this tool (1,200
pounds). Exceeding the maximum lifting capacities could cause personal injury
and/or property damage.
2. Make sure the Platform (8) is fully collapsed to the oor. Also, make sure the Remov-
able Plate (9) is properly positioned over the inspection hole of the Platform (8).
3. With assistance, roll the motorcycle up the Ramp (10) and onto the Platform (8)
until its front wheel contacts the Stop Plate (1). Then, kick the center stand of the
motorcycle down to stabilize it on the Lift.
4. Adjust the Vise assembly (4, 6, 7), and clamp the bottom of the front motorcycle
wheel into the Vise assembly. Then, resecure the Vise assembly to the Platform
(8). You should also stabilize the motorcycle using tie-down straps (not included) on
each side of the motorcycle with one end of the straps tied to the motorcycle and
the other end of the straps tied to the Platform (8).
5. Connect the air compressor’s hose to the Foot Valve Air. Then turn on the air
compressor and set its regulator to 110 to 125 PSI. Do not exceed 125 PSI. (See
Figure B.) Make sure the Foot Air Valve (48) is located on the oor surface and
safely away from the Motorcycle Lift so as to avoid damaging the Foot Air Valve.
(See Figure A.) Step on and hold down the right side of the Foot Air Valve (48) until
the Platform (8) of the Motorcycle Lift reaches its maximum height. Then step on
and hold the left side of the Foot Air Valve until the Platform is fully collapsed to the
oor. Repeat this procedure several times to ensure the Motorcycle Lift is operating
properly. (See Figure A.)
6. When the Platform (8) has been raised to the working height, lower the Safety Bar
(11) completely to prevent the Motorcycle Lift from accidentally lowering.
7. When work on the motorcycle is completed, check under the Motorcycle Lift to make
sure there are no tools, motorcycle parts, etc. and that it is safe to lower the Lift.
8. Swing the Safety Bar (11) aside. Then step on and hold down the left side of the
Foot Air Valve (48) to slowly lower the Platform (8) to the oor.
9. With assistance, remove the tie-down straps from the motorcycle. Loosen the Vise
assembly (4, 6, 7). Kick the center stand of the motorcycle up. Then, slowly back
the motorcycle completely off the Motorcycle Lift.
10. Turn off the air compressor. Step on and hold down the left side of the Foot Air Valve
(48) to release any remaining compressed air in the system. Then, disconnect the
compressor’s air hose from the Foot Air Valve.
11. Make sure to store the Motorcycle Lift in a clean, dry, safe location out of reach of
children and other unauthorized people.