Filter
Top Products
SKU 43569 PAGE 4
2. While firmly holding Bar B with one hand, press in both knobs of the Spring Clamp
(part #9) and extend Bar A (part #8) until the Rubber Spacers (part #1) are pressed
against the cargo toward the front of the truck bed and against the truck tailgate at
the rear end .
3. Release the knobs of the Spring Clamp, and either extend or collapse the length
of the Cargo Retaining Bar until the knobs of the Spring Clamp self-insert into the
nearest Adjusting Hole located on Bar B.
4. Depending on the final adjustment length (up to 6”) required to firmly brace the
Cargo Retaining Bar between the cargo and the truck tailgate, twist Bar A and/or
Bar B
counterclockwise
as needed to extend the Stands at either end.
2. Hand screw the two Stands (part #3)
inward until they are flush with the ends
of Bar A (part #8) and Bar B (part #11).
3
11
9
11
8
3
8