Filter
Top Products
SKU 36396 Page 4
Note: Only use pins that are intended for supporting this type of Jack, are capable of
supporting 3 Tons, and ensure that the pins are properly secured before use.
Note: This Jack is not intended for horizontal use.
2. Insert the Handle (26) into the Handle Socket (27).
Raising and Lowering
1. To raise the Hydraulic Jack turn the Release Valve (18) clockwise until the valve is tightly
closed. Pump the Handle (26) to raise the Jack. Continue to pump the Handle (26) until the
Hydraulic Jack is at the desired height.
2. To lower the Jack, first verify that the area under the object is clear, then turn the Release Valve
(18) counterclockwise. This will release pressure in the Jack and cause the Jack to lower.
Adding Hydraulic Oil
1. Turn the Release Valve (18) counterclockwise until Jack is completely lowered. Remove the
Oil Plug (11) from the Oil Chamber (10). Fill the Oil Chamber (10) with oil. Use a high quality
hydraulic oil. Note: The capacity of the oil chamber is 17.6 ounces.
Hydraulic System Bleeding Instructions
If the Hydraulic Jack begins to lose power and efficiency, it may be a result of air being trapped
in the hydraulic system. Follow the steps shown below to bleed the air from the hydraulic system.
Caution: Make certain that the Hydraulic Jack is not under load while bleeding the system.
1. Remove oil chamber’s Oil Plug (11).
2. Pump the Handle (26) to raise the Jack to its highest position. Open the Release Valve (18).
Release the Handle (26) to lower the Jack. Repeat pumping the Handle a number of times to
force the hydraulic oil through the system.
3. Top off the oil chamber with hydraulic oil. Tighten the Oil Plug (11). The bleeding process is
now complete.
4. Test the Hydraulic Jack to be certain it is working properly. Only proceed after you ensure that
it is working properly.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY
REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE
ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE
PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS
AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS
AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER
REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR
HER INSTALLATION OF REPLACEMENT PARTS THERETO.