Filter
Top Products
Page 3SKU 03029 For technical questions, please call 1-800-444-3353.
INSPECTION AND MAINTENANCE
1. WARNING! Always unplug the Off Road Truck Light System from its 12 Volt DC power source and
allow the unit to completely cool down before performing any inspection or maintenance.
2. BEFORE EACH USE, inspect the general condition of the Off Road Truck Light System. Check for
misalignment or binding of moving parts, cracked or broken parts, damaged Wiring, damaged Lens/
Lens Guard, and any other condition that may affect its safe operation. If a problem occurs with the
Lights, have the problem corrected before further use. Do not use damaged equipment.
3. TO CHANGE THE 100 WATT HALOGEN BULB, open the Lens Guard and remove the Lens. Using
gloves or a soft cloth, gently press the Bulb to one side of the Socket and remove the opposite end.
Reverse this procedure to install a new Bulb. NOTE: Do not touch the new Bulb with your fingers, as
oil in your skin will damage to the Bulb if not cleaned off before use.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE DIAGRAMS IN THIS MANUAL AS A REFER-
ENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR
WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE
PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE
MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE
BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT
OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT
PARTS THERETO.
FIGURE B
BLACK
GROUND
WIRE
4
2
1
LIGHT SWITCH
FUSE
(20 AMP)
BLUE
POWER (HOT)
WIRE
TO FUSE BOX
OR
(+) BATTERY
TERMINAL
12 FT. RED EXTENSION WIRE
4 FT. RED EXTENSION WIRE
BLACK
GROUND
WIRES
“Y”
CONNECTOR
PASSENGER SIDE
DRIVER SIDE