Filter
Top Products
M0302 9
EN
I INITIAL START UP
FOREWORD Only start dispensing after making sure that assembly and
installation have been correctly performed.
WARNING
TOXIC FLUID OR FUMES HAZARD
The faulty operation of this device could cause the spill
of liquids that are hazardous for people and the envi-
ronment.
NOTICE
It is a good practice to only operate the nozzle lever
after making sure the spout has been properly in-
serted in the mouth of the tank to be filled.
NOTICE
When using for the first time and every time the
nozzle is used, following the connection of the sup-
ply hose, gently operate the lever to enable the air
to escape from the circuit, until normal operation is
achieved.
NOTICE
Check the correct operation of the automatic stop
device once the tank is full.
NOTICE
Keep fresh water in nozzle path to prevent DEF
crystals from forming on nozzle end. The nozzle au-
tomatic cut off may fail if crystallization plugs the
nozzle orifice. The nozzle tip must be submerged in
water when the nozzle is holstered.
J MAINTENANCE
1
PERIODICALLY CHECK THE CORRECT OPERATION OF THE AUTOMATIC
STOP DEVICE
2
IF FITTED, IT IS BEST TO PERIODICALLY CHECK THE FILTER AND CLEAN
IT EVERY 1000 LITRES OF TRANSFER.
3
PERIODICALLY CHECK THE TIGHTNESS OF THE CONNECTIONS
K MALFUNCTIONS
FOREWORD THE POSSIBLE CAUSES OF MALFUNCTION ARE MAINLY AT-
TRIBUTABLE TO THREE FACTORS:
1 NOZZLE DIRTY IN INNER HOLE OF LIP AT END OF SPOUT
2 OPERATING PRESSURE OF LIQUID TO BE DISPENSED BELOW
0.5 bar OR ABOVE 3.5 bar
3 FLOW RATE TOO LOW OR TOO HIGH
NOTICE
Correct and regular maintenance of the nozzle and
of the system to which it is connected prevents
malfunctions and possible accidental spills of haz-
ardous liquids.