Globalsat Technology BU-303 GPS Receiver User Manual


 
PAGE12 OF13
USB_GPS_WIN_ v2.1
USB GPS (WIN)
11. BU-303 SPECIFICATIONS
Electrical Characteristics (Receiver)
GPS Chipset SiRF Star II e/LP
Frequency L1, 1575.42 MHZ
C/A Code 1.023 MHz chip rate
Channels 12 all-in-view tracking
Sensitivity -147 dBm
Accuracy
Position Horizontal
10m 2D RMS WAAS enabled
15m 2D RMS WAAS disabled
Velocity 0.1m/sec 95% (SA off),
Time 1 micro-second synchronized to GPS time
WAAS Enabled for North America product s (USGlobalSat, Inc)
Datum
Datum WGS-84
Acquisition Rate
Hot start 8 sec., average (with ephemeris and almanac valid)
Warm start 38 sec., average (with almanac but not ephemeris)
Cold start 45 sec., average (neither almanac nor ephemeris)
Reacquisition 0.1 sec. average (interruption recovery time)
Protocol
GPS Protocol Default: NMEA 0183 (Secondary: SiRF binary)
GPS Output Data
SiRF binary >> position, velocity, altitude, status and control
NMEA 0183 MEA0183 V2.2 protocol, and supports
command: GGA, GSA, GSV, RMC, VTG, GLL v2.2 (VTG
and GLL are optional)
GPS transfer rate Software command setting (Default : 4800,n,8,1 for NMEA )
Dynamic Condition
Acceleration Limit Less than 4g
Altitude Limit 18,000 meters (60,000 feet) max.
Velocity Limit 515 meters/sec. (1,000 knots) max.
Jerk Limit 20 m/sec**3
Temperature
Operating -40°~ 176°F (-40°~ 80°C)
Storage -40°~ 176°F (-40°~ 80°C)
Humidity Up to 95% non-condensing
Power
Voltage 5V ±5%
Current 90mA typical
Physical Characteristics
Dimension 2.32" x 1.65" x 0.82" (59mm x 47mm x 21mm)
USB Cable Length 60" (152 cm)
Low Noise Amp
Amplifier Gain w/out cable 27 dB Typical
Filtering -25dB (+100 MHz)
Output VSWR 2.0 Max.
Voltage DC 3 ~ 5.0V
Current 15mA max @ 5VDC
Due to continuous product improvements, all specifications are subject to change without notice.
FCC NOTICE
This devicecomplies with part 15ofthe FCCrules.Operationis subjectto thefollowing twoconditions:
(1) This devicemay not cause harmfulinterference, and (2) This device must acceptanyinterferencereceived,including interference that may cause
undesiredoperation. FCCRF Exposurerequirements: Thisdevice anditsantenna(s) mustnotbeco-locatedor operationin conjunction with any other
antenna or transmitter. NOTE:THEMANUFACTURERIS NOTRESPONSIBLE FOR ANY RADIO ORTV INTERFERENCE CAUSED BY
UNAUTHORIZEDMODIFICATIONSTO THIS EQUIPMENT. SUCH MODIFICATIONS COULDVOIDTHE USER'SAUTHORITYTO OPERATE
THEEQUIPMENT.