Filter
Top Products
Please refer to your Owner’s Manual for more detailed information regarding your vehicle.
BASIC VEHICLE OPERATION INSTRUCTIONS:
• Disconnect the Charging Cord from the vehicle before operating
• Master Disconnect Switch (fi gure A) must be in the ON position
• Turn key clockwise to the ON position
• Fully release the parking brake
• Select driving mode (R, DL, or DH)
• Press accelerator pedal and go
SERVICE CODES
(The Service Code is displayed in the same location as the mph/kph
and is accompanied by the Service Wrench icon.)
[06] Indicates that the accelerator pedal is pressed and no
direction has been selected. Release accelerator pedal and
insure direction switch is locked into position.
[11] Indicates accelerator pedal is pressed before key is turned to
the ON position. Turn key to OFF position. Release
accelerator pedal. Turn key to ON position.
[15] Indicates a low state of charge for the batteries. Fully charge
batteries before operating.
[16] Indicates that there is a high state of charge for the batteries.
Turn headlights on for several seconds, then turn key switch
to the OFF position and then to the ON position.
* If you see other Service Indication Codes please contact your dealer for service.
HOW TO KNOW IF CHARGE IS AT 100%
After charging is 100% complete, the charger connected icon will be the only thing lit
and the bar graph will not be illuminated. A green light on the charger itself will also
illuminate when the car is 100% charged. To know if the charging process is complete,
all ten bars on the state of charge indicator should be illuminated when the car is turn
on. If neither the charger connected nor the state of charge indicators are illuminated,
the charger may not be charging. If this occurs, make sure the main disconnect switch
is in the ON position. More information on the charger and charging of the batteries is
discussed on pages 48-52 of the Owner’s Manual.
← A