Filter
Top Products
13
This programmable transmitter can store
three frequencies for items such as a
garage door opener, entry door lock or
security system. With the ignition OFF,
program the transmitter as follows:
• Hold down the desired button on the
unit until the red indicator light flashes
slowly (about 20 seconds); continue
holding down the button
• Hold the end of your hand-held trans-
mitter up to three inches away from
the surface of the universal transmit-
ter and hold down the button
• Up to 90 seconds may pass as the
universal transmitter is being pro-
grammed; programming is complete
when the red light on the HomeLink®
transmitter flashes rapidly
• Release both buttons
For garage door openers with a “rolling
code,” continue with the following steps:
• Press the training button on the
garage door opener motor head unit,
making sure that the indicator light
flashes to confirm training mode
• Within 30 seconds, press and hold
the HomeLink® transmitter button
programmed in the previous steps
• Press and release this button up to
three times to ensure that the
HomeLink® transmitter has been
trained
See Section 2 of your Owner Manual.
Rainsense Wipers
On equipped vehicles, these wipers
detect moisture on the windshield and
automatically turn the wipers on.
Remote Keyless Entry (RKE)
System
The RKE system locks and unlocks the
doors and liftglass from a range of three
to 30 feet. At times the range may be
shorter than usual, which is normal. If
the transmitter doesn’t seem to be work-
ing properly:
• Ensure that you are within transmitter
range of the vehicle. Rainy and
snowy weather can reduce transmit-
ter range
• Check to see whether other vehicles
or obstacles are blocking the trans-
mitter signal by stepping a few feet to
the left or right, and hold the transmit-
ter higher when pressing the
button(s)
• Consider the length of time that the
transmitter battery has been in serv-
ice and replace it if necessary (the
DIC will display “RFA BAT # LOW” if
the battery needs replacing). Use CR
2032 battery or equivalent
See Section 2 of your Owner Manual.
To activate Rainsense, set the wipers to
one of the five delay settings on the turn
signal/multifunction lever. The rain sen-
sor automatically controls the frequency
of the wipes from OFF to HIGH speed
according to the amount of moisture on
the windshield.
See Section 3 of your Owner Manual.
Note: Turn this feature off before enter-
ing an automatic car wash.
Bravada2004 beta5 5/6/03 11:11 PM Page 13