Filter
Top Products
20 c530 Owner’s Manual
APPENDIX
APPENDIX
Mounting on Your
Dashboard
Use the enclosed mounting disk to
mount your unit to the dashboard and to
comply with certain state regulations.
Important: The permanent mounting
adhesive is extremely difficult to remove
after it is installed.
To install the mounting
disk:
1. Clean and dry the dashboard where
you are placing the disk.
2. Remove the backing from the
permanent mounting adhesive on the
bottom of the disk.
3. Place the disk on the dashboard.
4. Place the suction cup mount on top
of the disk.
Flip the
lever down
(toward the
disk).
Resetting Your c530
If your unit locks up (freezes up), press
and hold the
Power button to turn off
the unit. Then turn the unit back on. If
this does not help, reset your c530.
To reset the c530:
1. Place your thumb nail in the groove
located under the Garmin logo on the
faceplate.
2. Gently pull off the faceplate.
Reset
button
Power button
Faceplate
3. Press the Reset button.
4. Connect the c530 to a power source
using the power cable. The c530
should automatically turn back on
and operate normally.
NOTE: If you need to reset your unit
often, update the system software.
See page 23 for information about
updating the software.
Disk
Suction
cup
mount
Lever