Filter
Top Products
iQue M3 Quick Reference Guide 17
Mount the iQue M3
Adjusting knobs
Suction lever
Suction
cup
Pivoting joint rotates to the left or right
Cradle
To install the suction mount:
1. Loosen the adjusting knobs (shown above). Then
extend the mount and retighten the knobs.
2. Clean and dry the windshield and the suction cup
with rubbing alcohol.
3. Make sure the suction lever is up (pulled away from
the suction cup). Position the suction mount on your
windshield. Press the suction cup firmly against the
glass and rock it to remove as much air as possible.
4. Press the suction lever down toward the windshield.
5. Gently slide the iQue M3 down into the cradle until it
clicks into place.
6. Loosen the adjustment knobs and re-position the
mount, if necessary. Then tighten the knobs firmly.
To remove the suction mount from the windshield, pull the
suction lever up away from the windshield. If necessary,
pull the tab on the bottom of the suction cup toward you.
Contact Garmin
If you encounter any difficulty while using your iQue
M3, or if you have any questions, in the U.S.A. contact
Garmin Product Support at 913/397.8200 or 800/800.1020,
Monday–Friday, 8 AM–5 PM Central Time; or by e-mail at
support@garmin.com. In Europe, contact Garmin (Europe)
Ltd. at 44/0870.8501241.