Filter
Top Products
GVN 52 Owner’s Manual 41
APPENDIX
APPENDIX
Using the Remote Control
The remote control uses two AAA batteries. Do not mix
old and new batteries together. If the remote does not
work, install fresh batteries. If this does not correct the
problem, you can re-pair the remote control with the
GVN 52. You must also follow this procedure to use a
replacement remote control.
To pair your remote with the GVN 52:
1. Press and hold the Thumb Stick and the 0 key on
the remote for 10 seconds.
2. Follow the instructions
on the screen; enter the
correct numbers. The
remote control pairs with
the GVN 52.
Updating the Software and Map Data
To update the navigation system software, you must
have an SD card, an SD card reader, and an Internet
connection.
To update the navigation software:
1. Go to www.garmin.com/support/download.jsp.
2. Click
Additional Software.
3. Select
GVN 52 from the list of products.
2. Click
Download next to the navigation system software.
3. Read and agree to the terms. Click
Download.
4. Select
Save. Then save the update onto an SD card.
5. Insert the SD card into the side of the GVN 52. Make
sure the system is powered on. Your software is updated
automatically.
You can purchase map data updates from Garmin. Check
www.garmin.com/unlock/update.jsp to see if an update
for your map software is available.