Filter
Top Products
Page 14 190-00355-04
GDL 69/69A XM Satellite Radio Activation Procedures Rev. J
Figure 4-2. Data Link Status Page
5. Refer to Table 4-1 to read the SAT ID/CONNECTIVITY information.
6. Verify radio IDs and signal quality is between 2 – 3. If signal quality is zero, check the antenna and
wiring.
Table 4-1. Data Link Status
SAT ID Field
„- -„
GDL 69/69H – 430/530 Series interface communications not yet established.
„XM‟
GDL 69/69H not yet communicating with internal satellite radio hardware (normal
during power-up).
„X0‟, „X1‟, „X2‟, or „X3‟
„X‟ = Satellite radio service activated. Satellite signal quality is indicated by the
numbers 0, 1, 2, or 3; where 0=none, 1=poor, 2=good, and 3=excellent.
„-0‟, „-1‟, „-2‟, or „-3‟
„-‟ = Satellite radio service is not activated. Satellite signal quality is indicated by
the numbers 0, 1, 2, or 3; where 0=none, 1=poor, 2=good, and 3=excellent.
Connectivity Field
“Searching...”
No satellite is currently in view, signal quality is „0‟.
“Satellite in view”
Indicates a signal quality between 1 and 3.
4.3 Verify XM Subscribed Services
The 430/530 supports the following weather services: NEXRAD, graphical METAR, text-based
METAR, Wind, and Graphical Temperature/Dew Point. These services are available only in the
United States. Verify included services by displaying them on the unit, if applicable. If signal quality is
between 1 and 3, but no data is displayed, contact XM Satellite Radio to verify subscription. Be sure that
the unit is updated with the most current software.