Filter
Top Products
Battery Warnings
Your GPS unit may use an internal, non-user-replaceable
battery for various purposes, such as the real-time clock.
Do not remove or attempt to remove the non-user-
replaceable battery.
When disposing of the unit, take it to a professional
service, such as a waste electronics treatment facility,
to have the battery removed and recycled.
Important Information
MAP DATA INFORMATION: One of the goals of
Garmin is to provide customers with the most complete
and accurate cartography that is available to us at a
reasonable cost. We use a combination of governmental
and private data sources, which we identify in product
literature and copyright messages displayed to the
consumer. Virtually all data sources contain some
inaccurate or incomplete data. In some countries,
complete and accurate map information is either not
available or is prohibitively expensive.
The California Electronic Waste Recycling Act of
2003 requires the recycling of certain electronics. For
more information on the applicability to this product, see
www.erecycle.org.
Caring for the Unit
The case is constructed of high quality materials and
does not require user maintenance, except cleaning.
Cleaning the Case
Clean the unit’s outer casing (except for the screen) using
a cloth dampened with a mild detergent solution and then
wipe dry. Avoid chemical cleaners and solvents that may
damage plastic components.
•
•
Cleaning the Screen
The unit’s lens is coated with a special anti-reective
coating that is sensitive to skin oils, waxes and abrasive
cleaners. Cleaners containing ammonia, alcohol,
abrasives, or anti-grease detergents will harm the anti-
reective coating. It is important to clean the lens using
an eyeglass lens cleaner (that is specied as safe for
anti-reective coatings) and a clean, lint-free cloth.
Water Immersion
The unit is waterproof to IEC Standard 60529 IPX7.
It can withstand immersion in 1 meter of water for 30
minutes. Prolonged submersion can cause damage to the
unit. After submersion, be certain to wipe and air dry the
unit before reuse.
Industry Canada Compliance
NOTE: The following statement does not
apply to shnders.
Category I radiocommunication devices comply with
Industry Canada Standard RSS-210. Category II
radiocommunication devices comply with Industry
Canada Standard RSS-310.
FCC Compliance
NOTE: The following statement does not
apply to shnders.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.