nüvi 3500 Series Owner’s Manual 71
4
Place the silver tip in the end piece.
5
Screw the end piece back into the vehicle
power cable
➍.
Mounting on Your Dashboard
The permanent mounting adhesive is extremely
difcult to remove after it is installed.
Use the mounting disk to mount your device to
the dashboard and comply with certain state
regulations. See www.garmin.com for more
information.
1
Clean and dry the dashboard where you are
placing the disk.
2
Remove the backing from the adhesive on
the bottom of the disk.
3
Place the disk on the dashboard.
4
Remove the clear plastic cover from the top
of the disk.
5
Place the suction cup mount on top of the
disk.
6
Flip the lever down (toward the disk).
Removing the Device, Cradle, and
Mount
Removing the Device from the Cradle
1
Press the tab on the bottom of the cradle.
2
Tilt the device forward.
Removing the Cradle from the Mount
1
Turn the cradle to the right or left.
2
Apply pressure until the socket on the cradle
releases the ball on the mount.
Removing the Suction Cup Mount from
the Windshield
1
Flip the lever on the suction cup mount
toward you.
2
Pull the tab on the suction cup toward you.
