Filter
Top Products
2
Plotter
Returning Own Ship to Screen
Center
Press the CENTER soft key.
Adjusting Brilliance
1. Press the BRILL key to show the
BACKLIGHT window.
2. Rotate the ENTER knob to adjust the
brilliance.
3. Push the ENTER knob to close the
window.
Entering Waypoints
1. Operate the cursor pad to place the
cursor at the position desired.
2. Press the MOB/WPT key. Finally, press
the ENTER knob.
Entering Routes
1. Operate the cursor pad to place the
cursor at the position desired.
2. Press the ROUTE key, and then press
the SAVE soft key.
3. Repeat steps 1 and 2 to complete the
route.
Setting Destination
Operate the cursor pad to place the cursor
on the waypoint you want to go, and then
press the GOTO key.
Setting Arrival Alarm
1. Press the MENU key.
2. Choose ALARMS from the menu bar,
and then push the ENTER knob.
3. Choose ARRIVAL ALARM and then
push the ENTER knob.
4. Rotate the ENTER knob to choose the
value and push it.
5. Enter the alarm range and then press
the ENTER knob.
Plotter display
Cursor
Own ship
mark
Nav data