Filter
Top Products
• the ignition is in the 4 (ON) position,
• the brake is pressed before reaching 5 mph (8 km/h), and
• then the vehicle increases to more than 5 mph (8 km/h).
Relock
The autolock feature repeats when:
• an “autolock” occurrence has already taken place,
• the brake is depressed while vehicle speed is less than 5 mph (8
km/h),
• all vehicle doors become closed again, and
• then the vehicle increases to more than 5 mph (8 km/h).
Deactivating/activating the autolock feature
The autolock feature can be enabled or disabled by the keyless entry
keypad (if equipped) on your door, driver configuration mode or by your
authorized dealer.
Deactivating/reactivating the autolock feature using the keypad
(if equipped)
Your vehicle comes with the autolock feature activated. To
deactivate/reactivate this feature:
1. Turn the ignition to the 3 (OFF) position.
2. Close all the doors.
3. Enter the 5-digit entry code.
4. Press and hold the 7 • 8. While holding the 7 • 8, press the 3 • 4.
5. Release the 3 • 4.
6. Release the 7 • 8.
The horn will chirp once when the system has been successfully
deactivated.
The horn will chirp twice (one short and one long chirp) when the
system has been successfully reactivated.
To deactivate/reactivate the autolock feature using the power door
unlock control
You must close all the vehicle doors and complete Steps 1-7 within 30
seconds or the procedure will have to be repeated. If the procedure
needs to be repeated, you must wait 30 seconds.
2005 Freestar (win)
Owners Guide (post-2002-fmt)
USA (fus)
Locks and Security
107