Filter
Top Products
E-550 SUPER DUTY CUTAWAY
DIMENSIONAL DATA
E
B
B
E
W3
W5
W117
C
L
OUTSIDE
FRONT
FASTENER
C
L
OUTSIDE
FRONT
FASTENER
SEAT
BASE
POINT A
SEAT
BASE
POINT A
PASSENGER – SEAT DRIVER – SEAT
IMPORTANT:
THE DIMENSIONS IN THIS FIGURE REQUIRE THE VEHICLE TO BE AT
DESIGN POSITION. E–SERIES VEHICLES AT DESIGN POSITION
WILL BE LEVEL FRONT TO REAR, AND SIDE TO SIDE, ON THE UPPER
SURFACE OF THE RIBBED FLOOR PANEL FROM THE B–PILLAR REARWARD.
TORSO ANGLE
OUTSIDE
FRONT
FASTENER
POINT A
SEAT BACK
PIVOT
HEEL
POINT
A
D
THE TORSO ANGLE IS DETERMINED BY
USING THE METHOD SPECIFIED IN
SAE J826 (MAY 1987)
C
L
H61
L34
DRIVER SIDE ONLY
F
C
510.0
HIP ROOM – FRONT
EFFECTIVE HEAD ROOM – FRONT
MAXIMUM EFFECTIVE LEG ROOM – FRONT
SHOULDER ROOM – FRONT
H61
L34
W3
W5
CODE DESCRIPTION
FRONT COMPARTMENT
W117 BODY WIDTH AT H–POINT
1015 [39.9]
1736 [68.3]
BB0686
C
L
VEHICLE
18_ DRIVER
21_ PASSENGER
DIMENSIONS
[20.08]
6.0
[0.24]
1666 [65.6]
1999 [78.7]
1079 [42.5]
SgRP - HAS A 12.7 [0.50] RADIAL
TOLERANCE PERMITTED FROM
BASE SgRP
NOTE [ ] DIMENSIONS ARE INCHES.
click
here
TO RETURN TO INDEX
Page 18 E-550 SUPER DUTY CUTAWAY
SgRP INFORMATION
(SEAT POSITION IS 10.0 [0.39] FORWARD OF
REARMOST POSITION)
POINT A
(SEAT POSITION IS AT THE MIDPOINT OF
AVAILABLE TRAVEL)
A B C D E F
DRIVER - SEAT (CUTAWAY) 217.8 [8.57] 105.0 [4.13] 384.2 [15.13] 356.0 [14.01] 67.0 [2.64] 937.4 [36.90]
PASSENGER - SEAT (CUTAWAY) 277.3 [10.92] 103.0 [4.06] 377.0 [14.84] 412.0 [16.22] 65.0 [2.56] 960.0 [37.80]