Filter
Top Products
HEADLAMP CONTROL
Turning the headlamp control
clockwise to the first position
turns on the parking lamps,
instrument panel lamps,
license plate lamps, and the
tail lamps. Continuing to turn
the headlamp control to the
second position turns on the
headlamps. To use the
autolamp light-sensitive,
automatic on-off control for
the headlamps, turn the
headlamp control
counterclockwise. To turn
autolamps off, turn the
control clockwise to the OFF
position. To activate the high
beams, simply pull the turn
signal lever towards you to
the second detent. Pull the
lever towards you again to
deactivate high beams. Use
the same lever to activate the
“Flash to Pass” feature. Pull
the lever towards you to the
first detent to activate and
release it to deactivate.
1
PANEL DIMMER
Use to adjust the brightness
of the instrument panel and
all applicable switches in the
vehicle during headlamp and
parking lamp operation.
Move the control to the full
upright position, past detent,
to turn on the interior lamps.
2
FOGLAMP CONTROL
(IF EQUIPPED)
With the ignition on, the
foglamps can be turned on
when the headlamp control
is in the parking lamp,
headlamp or autolamp
position, and the high beams
are not on. Simply pull the
headlamp control toward you
to turn on the foglamps. The
foglamp indicator light will
illuminate. The foglamps will
not operate when the high
beams are activated.
3
WINDSHIELD WIPER
WASHER
The multifunction lever
controls the windshield wiper
modes, speeds, and the
windshield washer. For
intermittent operation, move
the control up one position.
You can then adjust the
rotary control to the desired
interval speed. For normal or
low wiper speed, move the
control up two positions from
OFF. For high speed
operation, move the control
up three positions from OFF.
For windshield washer
control, pull the end of the
lever toward you. With a
quick pull and hold, the
wipers will swipe three times
with washer fluid. With a long
pull and hold, the wipers will
activate washer fluid for up to
ten seconds.
4