Filter
Top Products
SHIFT TO PARK (if equipped) — Displayed when the start/stop
button is pressed to shut off the engine with the shift select lever in any
position other than P (Park). Refer to Fast restart feature in Push
button start system in the Driving chapter for more information.
NO KEY DETECTED (if equipped) — Displayed if the Intelligent
Access Key is not detected by the system in the following three
scenarios:
• When the start/stop button is pressed in an attempt to either start the
engine or cycle through the ignition states.
• When the engine is running and a door is opened then closed.
• When the vehicle’s speed exceeds 10 mph (16 km/h) for the first time
after starting. Refer to Push button start system in the Driving chapter
for more information.
RESTART NOW OR KEY IS NEEDED (if equipped) — Displayed
when the start/stop button is pressed to shut off the engine and a
Intelligent Access Key is not detected inside the vehicle. Refer to Push
button start system in the Driving chapter for more information.
ACCESSORY POWER ACTIVE (if equipped) — Displayed when the
vehicle is in the accessory ignition state.
STARTING SYSTEM FAULT (if equipped) — This message is
displayed when there is a problem with your vehicle’s starting security
system; your vehicle will not be able to start. See your authorized dealer
for service.
KEY PROGRAMMED 3 KEYS TOTAL (if equipped) — Displayed
during spare key programming, when a third Intelligent Access Key is
programmed to the system.
KEY PROGRAMMED 4 KEYS TOTAL (if equipped) — Displayed
during spare key programming, when a fourth Intelligent Access Key is
programmed to the system.
MAX # OF KEYS LEARNED (if equipped) — Displayed during spare
key programming, after a fourth Intelligent Access Key is programmed or
upon entering spare key programming mode with four Intelligent Access
Keys already programmed to the vehicle.
MY KEY ACTIVE DRIVE SAFELY — Displayed at startup when
MyKey™ is in use. Refer to MyKey™ in the Locks and Security chapter
for more information.
KEY COULD NOT PROGRAM — Displayed when an attempt is made
to program a spare key using two existing MyKeys. Refer to MyKey™ in
the Locks and Security chapter for more information.
Instrument Cluster
28
2010 Taurus (500)
Owners Guide (own2002), 1st Printing
USA (fus)