Filter
Top Products
The remote entry system activates the illuminated entry feature. This
feature turns on the lamps for 25 seconds or until the ignition is turned
to the on position. The dome lamp control must be set to the ON
position in order for the illuminated entry feature to operate.
Programming unlocking mode (if equipped)
The unlocking mode on the remote entry transmitter can be
programmed. To change the unlocking mode from the single-door
unlocking mode to the central all-door unlocking mode:
• With the vehicle in the off position, press the
and on the
remote entry transmitter simultaneously and hold for four seconds.
The turn lamps will illuminate twice to indicate the mode change.
• Press the
and on the remote entry transmitter simultaneously
and hold for four seconds to switch between unlocking modes.
Locking the doors
• Press and release to lock all doors. Note: The parking lamps will
illuminate. If any door or trunk is ajar, the lamps will not illuminate.
Once the door that was ajar is closed, the lamps will illuminate to
indicate that the vehicle is locked and all doors are closed.
• Press
and release again within three seconds to confirm all doors
have locked. Note: The horn will honk once and the turn lamps will
illuminate if all doors are closed. The horn will honk twice if any door
is ajar.
Car finder
Press
twice within three seconds. The horn will chirp and the turn
lamps will flash. It is recommended that this method be used to locate
your vehicle, rather than using the panic alarm.
Sounding a panic alarm
Press
to activate the alarm. Press again or turn the ignition to the on
or accessory position to deactivate, or wait for the alarm to time out in
three minutes.
Note: The panic alarm will only operate when the ignition is in the off
position.
Opening the luggage compartment
Press
once to open the luggage compartment. Note: This feature
will only operate with the ignition in the off or the accessory position.
Locks and Security
75
2010 Focus (foc)
Owners Guide, 1st Printing
USA (fus)