Filter
Top Products
Tips for setting codes:
• The factory set code cannot be erased or changed.
• The factory code will work even after you have set your own personal
codes.
• Do not set a code that uses five of the same number.
• Do not use five numbers in sequential order.
Erasing personal code
1. Enter the factory set 5–digit code.
2. Within five seconds of entering the factory code, press and release the
1 • 2 control. The door locks will lock and quickly unlock to confirm
entry into the programming mode.
3. Within five seconds of Step 2, press and hold the 1 • 2 for two
seconds to erase the customer programmed code.
The programming mode is exited after five seconds of keypad inactivity.
The door locks will lock and quickly unlock to confirm programming
mode has been exited.
The personal code is now erased and only the factory set 5–digit code
will work.
Unlocking and locking the doors using keyless entry
To unlock the driver’s door, enter the factory set 5-digit code or your
personal code. Each number must be pressed within five seconds of each
other. The keyless entry keypad will illuminate after pressing the first
control on the keypad.
To unlock all doors, press the 3 • 4 control within five seconds.
To lock all doors, press the 7 • 8 and the 9 • 0 at the same time. You
do not need to enter the keypad code first. Note: The interior lamps
will turn off.
To open (or close) the power sliding doors (if equipped), press the
5 • 6 control within five seconds to open (or close) the left power
sliding door or the 9 • 0 control in order to open (or close) the right
power sliding door.
2007 Freestar (win)
Owners Guide (post-2002-fmt)
USA (fus)
Locks and Security
108