Filter
Top Products
Power Down Back Window (if equipped)
To operate the power down back window, the ignition switch must be in
the On or Accessory position (or with accessory delay power enabled).
The power down back window only has three window position selections:
• Fully open
• Vent
• Fully closed
All rear seat occupants and/or cargo must be properly restrained
and clear of the back window opening before operating the
power down rear window.
Press and release the control to
lower window to the vent position.
Press and release the control again
to lower window to the full open
position.
Press and release the control to
raise the window all the way to the
full closed position.
Normal Operation
If an “up” command is selected and the ignition is switched to OFF or
ON during window travel (or with accessory delay power enabled), the
window will:
1. Stop if it is between the vent position and fully closed or
2. Continue to move up to the vent position if it is between vent and
fully open
3. Window is moving up from the full open position
4. Window is moving up and is past the vent position
5. Window is moving up and is at the anti-pinch shut off point
If a “down” or “vent” command is selected and the ignition is switched to
OFF or ON during window travel (or with accessory delay power
disabled), the window will:
1. Move down to the fully open or vent position
2. Window is moving down and is between closed and vent
2007 07+ Explorer Sport Trac (esp)
Owners Guide (post-2002-fmt)
USA (fus)
Driver Controls
57