Filter
Top Products
2. Position the end of your hand-held transmitter 1–3 inches (2–8 cm)
away from the HomeLink button you wish to program (located on your
overhead console) while keeping the display in view.
3. Simultaneously press and hold
both the HomeLink and hand-held
transmitter button. The message
CHANNEL “X” (1,2 or 3) TRAINING
will appear on the display. Do not
release the buttons until step 4
has been completed.
Some entry gates and garage door openers may require you to replace
step 3 with procedures noted in the “Gate Operator and Canadian
Programming” section for Canadian residents.
4. When the message CHANNEL “X”
(1,2 or 3) TRAINED appears on the
display, release both the HomeLink
and hand held transmitter buttons.
• DID NOT TRAIN will be displayed
if the channel did not properly
train.
5. Press and hold the just-trained HomeLink button and observe the
HomeLink house icon on the display. If the indicator light(s)
REVIEW COPY
2005 Crown Victoria (cro), Owners Guide (post-2002-fmt) (own2002),
Market: USA_English (fus)
Driver Controls
56