Ford 2004 Excursion Automobile User Manual


 
Note: If the red light blinks rapidly for two seconds and then turns to a
continuous red, proceed with steps 6 through 8 to complete
programming of a rolling code equipped device.
6. At the garage door opener receiver (motor-head unit) in the garage,
locate the learn or smart button (usually near where the hanging
antenna wire is attached to the unit).
7. Press and release the learn or smart button. (The name and color
of the button may vary by manufacturer.)
Note: There are 30 seconds in which to initiate step eight.
8. Return to the vehicle and firmly press, hold for two seconds and
release the HomeLink button. Repeat the press/hold/release sequence
again, and, depending on the brand of the garage door opener (or other
rolling code equipped device), repeat this sequence a third time to
complete the programming.
HomeLink should now activate your rolling code equipped device. To
program additional HomeLink buttons begin with step 2 in the
Programming section. For questions or comments, please contact
HomeLink at www.homelink.com or 18003553515.
Gate Operator & Canadian Programming
During programming, your
hand-held transmitter may
automatically stop transmitting
not allowing enough time for
HomeLink to accept the signal
from the hand-held transmitter.
After completing steps 1 and 2
outlined in the Programming
section, replace step 3 with the following:
Note: If programming a garage door opener or gate operator, it is
advised to unplug the device during the cycling process to prevent
overheating.
Continue to press and hold the HomeLink button (note step 3 in the
Programming section) while you press and release every two
seconds (cycle) your hand-held transmitter until the frequency
signal has been accepted by the HomeLink. The red indicator light
will flash slowly and then rapidly after HomeLink accepts the radio
frequency signal.
Proceed with step 4 in the Programming section.
2004 U137 Excursion (hdw)
Owners Guide (post-2002-fmt)
USA English (fus)
Driver Controls
76