Filter
Top Products
Note to Canadian residents
During programming, your hand-held transmitter may automatically stop
transmitting after two seconds which may not be long enough to
program the HomeLink Universal Transmitter.
If you are programming from one of
these hand-held transmitters:
• continue to hold the control on
the HomeLink Universal
Transmitter
• re-press the hand-held
transmitter every two seconds
You may have to repeat this function
several times while programming.
Operating the HomeLinkா Universal Transmitter
Once programmed, the HomeLink
Universal Transmitter can be used in
place of hand-held transmitters. To
operate, simply press the
appropriate channel control on the
transmitter (the red light will
illuminate, indicating the signal is
being transmitted).
Training a rolling code system
Rolling code systems (garage door openers which are “code protected”)
may be determined by the following:
• The hand-held transmitter appears to program the HomeLink
Universal Transmitter but does not activate the garage door.
• The garage door opener was manufactured after 1995.
Follow these steps to train a garage door with the rolling code feature:
1. Locate the training control on the garage door opener receiver. Refer
to the garage door opener manual or call 1–800–355–3515 if there is
difficulty locating the training control.
Controls and features
41