Filter
Top Products
R2510pr-0921
13
IMPORTANT! Use only a Power Wheels
®
6 volt (4.0 Amp/Hr.)
battery and built-in thermal fuse. Use of any other battery will
damage your vehicle. Make sure that you charge the battery for
at least 18 hours using the enclosed Power Wheels
®
6 volt
(4.0 Amp/Hr.) charger before operating your vehicle for the
first time. Charge the battery for at least 14 hours after each
use of the vehicle. Never charge the battery longer than 30
hours. Failure to follow these instructions may damage your
battery and will void your warranty.
• Remove the #8-18 x ⅞ " screw from the battery retainer. Lift to
remove the battery retainer from the vehicle.
• Place the Power Wheels
®
6 Volt (4.0 Amp/Hr.) battery in the
battery compartment. Make sure the battery connector extends
toward the rear of the vehicle.
• Replace the battery retainer over the battery. Insert the
#8-18 x ⅞ " screw through the battery retainer and into
the vehicle. Tighten the screw.
• Locate the lock fasteners on the front edge of the seat.
• Using a slotted screwdriver, turn both lock fasteners ¼ turn to
the unlocked position .
• Grasp under the front of the seat and lift firmly to remove it.
LOCKED UNLOCKED
Battery Connector
Battery Retainer
• Plug the battery connector into the motor harness connector.
Note: If the battery connector will not plug into the motor
harness connector, turn it over and try again! Do not force the
battery connector into the motor harness connector.
• Re-assemble the seat to the vehicle. Using a slotted screwdiver,
turn the lock fastener ¼ turn to the locked position
.
IMPORTANT! Always remember to keep the lock fasteners locked
at all times to prevent children from accessing the battery.
BATTERY INSTALLATION
1
2
3
4