Filter
Top Products
19
18
ASSEMBLY
L6349pr-0921
• Fit the tabs on the rear deck into the slots in the back end of
the vehicle.
• Insert two #8 x
3
/4" screws into the rear deck. Tighten the screws.
17
• Fit the long tabs on the hood into the slots in the front end of
the vehicle.
• Pull the hood forward and lower.
Note: The hood is held down by magnets. Simply lift to open the
hood. Do not use around items that are sensitive to or affected
by magnetic fields.
16
Hood
Hint: The seat is adjustable and has three positions. You can
move the seat back as your child grows.
• Insert both tabs on the front edge of the seat into one of the
sets of slots inside the vehicle.
• Choose the slots closest to the dash for shorter drivers and
the slots furthest from the dash for taller drivers.
Rear Deck
Short Seat Belts
Long Seat Belt
• Insert the fastener end of a short seat belt strap through the
slot near the outer edge of the seat. Make sure the side of the
seat belt with the fastener faces the outer edge of the seat.
• Pull the short seat belt strap completely through the slot until
the last T-loop at the opposite end of the belt catches against
the slot. You will pull one T-loop through the slot.
• Repeat this procedure to assemble the other short seat belt strap.
• Insert each fastener end of the long seat belt strap through
each slot in the center of the seat. Make sure the fasteners
face the outer edge of the seat.
• Pull each side of the long seat belt strap evenly through the
slots. Make sure to pull each T-loop through a slot.
Slots
FRONT VIEW
BACK VIEW
Seat
TOP VIEW
13