Filter
Top Products
3
• Fit an inside track marked “A” to track marked “A”.
• Insert three screws into the assembly and tighten.
• Repeat this procedure to join two additional “A”
track assemblies.
• Fit an inside track marked “B” to track marked “B”.
• Insert three screws into the assembly and tighten.
• Fit the pegs on the sides of a ramp into the holes in the
long ramp assembly, as shown.
Note: If the ramp does not fit, try the other ramp.
• Repeat this procedure to build the short ramp assembly.
• Set the ramp assemblies aside.
• “Snap” a ramp bar and ramp connector into one side
of a long ramp rail.
• “Snap” the other long ramp rail to the assembly.
• “Snap” the ramp spinner onto the support bar.
1
2
Assembly
• Fit the four center tracks together, as shown.
5
Ramp Bar
Ramp
Spinner
Ramp
Connector
Long
Ramp Rail
3
A
A
4
B
B